STANDARD EQUIPMENT LIST
Wheelhouse & Cockpit
Red/White Light in Wheelhouse
Courtesy Lights in Wheelhouse & Cockpit
12v Outlet supplied at Helm station
Custom Electronics area for Flush Mounting Electronics
Hydraulic Steering with Tilt-Wheel
Large Storage and Access Hatches in Deck
T-Handle Lock Downs on all cockpit hatches
Large Fish/ Storage Box in Transom
Sliding Helm Seat with Swivel
Navigation Station with Crew Seating
Drawers and Tackle Storage
Pantograph Windshield Wipers (3)
Drink Holders installed in Wheelhouse
Sliding Windows Port and Stbd
Forward Deck Area
Wide, Unobstructed Side Decks
Large Mooring Bit with Bow Pulpit
S/S Extended Bow Rail To Back of Wheelhouse
(6) Large S/S 10” Mooring Cleats
Stainless Steel Horn
(2) Hatches access Anchor Locker
Large opening Hatch in Forward Cabin Roof
(8) Portholes with Screens in Forward Cabin
Grab Rails on Wheelhouse Roof and Sides
Fully Vented Center Windshield
Radar Arch with Antenna and Radar Pads
30” Transom rail w/ center lifeline
Mechanical/ Electrical
Bow Thruster with Electronic Control
Hydraulic Steering
Easy Access to Circuit Breaker Panel
Full Engine Instrumentation with Audible Alarms
Dockside 30 AMP Service
Ample 110v Outlets throughout with GFI Protection
Large Hatch with Bennet Hatch Lifter
Fresh Water Cooled Engine
Hydraulic Trim Tabs
30 AMP Battery Charger
Shaft 1.50” Aquamet 22 Stainless Steel
TIDES™ Shaft Seal
Propeller 4 Bladed Nibral
Seacocks & Strainers are Bronze
All Thru-Hull Fittings are Bonded
(3) Electrical Bilge Pumps and (1) Manual Pump
Aft Cabin
Large U-shaped berth converts to Queen
Reading Lights throughout
Red/ White Dome Lights throughout
Courtesy Lighting
Vinyl Headliner
Full access to mechanical componets
Four Opening Ports
Carpet throughout Boat
Cabin/ Galley Area
S/S Sink with Pressurized Water System
Hot Water Heater Heated by Engine and 110v
Microwave Oven, 110v
Butane Stove
Refrigerator 2.8 cuft. 12v DC/ 110v AC
Head/ Shower Full Size Marine Toilet w/10 gal Holding Tank w/ dedicated Sump Pump
Accent Lighting in Cabin & Head
Courtesy Lights in Cabin & Head
Ample Drawers, Cupboards and Lockers
Dinette Seating area converts to Queen sized Berth
Large Single Berth aft of Galley Area AM/ FM Stereo CD Player
Upholstery & Carpet
Settee and Berth Cushions feature high-density foam with the Best Quality “Zip-On” Fabric Covers
Custom Cabin Headliner with Leather-grained Vinyl over insulated foam backing
Cabins are Carpeted and Color-Matched to interior Upholstery
Factory Options
Consult your Albin Dealer for complete details on Available factory installed options or custom work.
Construction
At Albin we use the best available materials for the construction of our ocean-going vessels.
Deck Hardware is through-bolted using aluminum backing plates.
Hull-to-deck joint is through-bolted and chemically bonded and
sealed using 3M’s "5200" adhesive.
We construct our boats using a combination of bi-axial & uni-directional FRP knitted products. All through-hull areas have solid reinforcement to prevent damage to the Hull/Deck Laminates.
By the use of these construction techniques, coupled with superior hull and interior designs, we enjoy the enviable reputation of fine sea-keeping qualities, comfortable and practical interiors with economy in use.
Specifications subject to change without notice. Please contact your dealer or Albin Marine.